×

Latest News

Thursday November 14, 2019

Controlling weld distortion


Weld distortion or deformation can occur as a result of the non-uniform expansion and contraction of the weld and base metal during the heating and cooling cycle.


How to limit and control weld distortion

Stresses form in the weld as a result of the changes in volume, particularly if the weld is restrained by the fixed components or other materials surrounding it. If the restraints are partly removed, these stresses can cause the base material to distort and may even result in tears or fractures. Of course, distortion can be very costly to correct, so prevention is important.

What are the main types of weld distortion?

Welder

There are various types of distortion and dimensional change including longitudinal; transverse; angular; twisting and bowing. Two or more types of distortion may occur at the same time.

There are many factors that can cause welding or cutting distortion and it is very difficult to predict the exact amount of distortion that is likely to occur. Some of the factors that should be considered include the degree of restraint; the thermal and other properties of the parent material; inherent stresses induced from previous metal-working processes (such as rolling, forming and bending); design of weldment; accuracy of manufacture and the nature of the welding process itself – the type of process, symmetry of the joint, preheat and the number and sequence of welds required.

How to limit weld distortion

The effects of weld shrinkage can never be entirely eliminated but you can keep them to a minimum by taking a few practical steps as follows:

  • Reducing the metal weld volume to avoid overfill and consider the use of intermittent welding
  • Minimising the number of weld runs
  • Positioning and balancing the welds correctly round the axis
  • Using backstep or skip welding techniques, which involves laying short welds in the opposite direction
  • Making allowance for shrinkage by pre-setting the parts to be welded out of position
  • Planning the welding sequence to ensure that shrinkages are counteracted progressively
  • Shortening the welding time

When cutting, it is possible to limit distortion by supporting the plate so it can expand freely without buckling; ensuring the plate is flat; allowing sufficient weld material when cutting in from corners and using a jig-saw pattern to lock the cut pieces together when multiple cutting.

Distortion can be avoided or significantly reduced when welding structural steelwork by using fixing devices, such as strongbacks or wedges to pre-set seams in plates; flexible clamps to bring parts to the required gap before welding or clamps for thin sheet welding. Longitudinal stiffeners can also be used to limit this type of bowing. It is also important to use the correct welding sequence, such as welding the frame before a cover plate. Pre-bending or pre-setting techniques may also help to prevent distortion and water can be used to cool the process.

Welding Pipes and tubes can suffer distortion after welding, and this can be prevented by using strongbacks attached with straps and wedges inside or outside the longitudinal joint; using backing strips to overcome transverse shrinkage or pre-setting or using back to back pairs when welding flanges to pipes.
In summary, if welding distortion is likely to be a problem, it can be avoided or minimised by advance planning and following best practice.

Is it possible to correct distortion?

This can be achieved by mechanically removing the bowing using a press, shot peening, pneumatic hammering or stress-free vibration. Alternatively, a sizing fixture can be used to restore the distorted fabrication to its intended dimensions. Different heating techniques can also be used to correct distortion by applying local or spot heating in various ways.

Air Products is a leading supplier of quality shielding gases. Our qualified welding experts can help work with you to choose the optimal Maxx® welding gas and set-up in order to control and limit weld distortion.

To request a non-obligation consultation please contact us on 0800 389 0202 or email apukinfo@airproducts.com or fill in request form below.

Contact us for a free no obligation demonstration from an Air Products Welding Specialist and see the bigger picture for yourself.